How to disassemble and assemble the door safety interlock (5)

Last updated 24/02/2021 08:08
  • All the work to be performed inside the appliance requires specific skills and knowledge and may only be carried out by qualified and authorised Service Engineers 
  • This platform is not fitted with an ON/OFF switch. 
  • Before you access internal components, take the plug out of the socket to disconnect the power supply. 
  • Some of the components in the mechanical part could cause injuries, so wear suitable protection and proceed with caution. 
  • Always empty the appliance of all the water before laying it on its side. 
  • If the appliance has to be placed on its side for maintenance or another reason, lie it on its left side, to avoid the risk of any residual water falling onto the main circuit board. 
  • Never place the appliance on its right side (electronic control system side): some of the water in the detergent dispenser could leak onto the electrical/electronic components and cause these to burn

How to disassemble and assemble the door safety interlock

Word import image

Pull the edge of the bellows

Word import image

Remove the iron ring securing the bellow seal to the cabinet.

Word import image

Remove the part of the bellow seal concerned from the unit.

Unfasten the two screws securing the door safety interlock to the front panel.

Word import image

Cut the clamp (red arrow).

Remove the connector (blue arrow).

Recreate the initial conditions when re-assembling.