Tumble dryer displays error message E40

Last updated 05/12/2019 09:08

Issue:

  • Tumble dryer displays error message E40

Applies to:

  • Vented dryer
  • Condenser dryer
  • Heat pump dryer

Resolution:

1. Check if the door is closed correctly

Make sure that the laundry is not trapped between the appliance door and rubber seal.

2. Reset the appliance

  • Remove the plug from the socket, wait 30 seconds and then plug it in again (The same result may be achieved by using the safety switch).
  • After plugging in the appliance, switch it on and select a program.

3. Contact an Authorized Service Centre

If the above suggestions did not solve the problem, we recommend requesting a visit by a service engineer.

Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.


Warning: We do not recommend using the product until the problem has been completely fixed. Unplug the product and do not plug it in again until you are certain that it is OK to do so.

Was this article helpful?

service-electrolux

Book a repair

Having issues with your appliance? Book a reliable and professional service from our expert technicians to get your product up and running quickly.

spares-electrolux

Spare parts & Accessories

Find original spare parts for your appliance in our webshop and have them delivered directly to your door.